So I picked up a Mathews Halon 32 recently, I've shot a Hoyt Carbon Spyder 34 the past couple years and am super familiar with the Z5 cam and how to tune a cam 1/2 system. I have zero clue where to start tuning the Halon 32...so I threw it on the draw board and noted that the bottom cam hits the draw stops a 1/16" of an inch before the top. How do I correct this? Add a twist to the top side of the control cable? Once I do have the cams in sync I had planned on setting my centershot by walk back tuning and then bare shady tuning from there. Is shooting through paper even necessary if I stick with bare stat tuning? Also, can someone explain how to fix lateral nock travel with a bare shaft using the top hats?