Done it. Im not concerned about process… Was asking about dremeling out area of stock for adhesion? I have not taken material out befor with fine results. Yet its been shared a few times to create area… Think ill just take out 1/8 max depth on a few areas cant hurt, tang etc…
Opinions on dremeling out area for bedding to adhere to? Ive had good luck just bedding recoil lug with tape only on bottom of lug. 1/4 moa gun. New stock ready to bed with marine tex. Kinda a keep it simple guy with this stuff. But no less right is right, thanks… forgot to mention its a CA FFT...
Pros and cons to both. Solo brings a different level of mental awareness and strength to stay course, not getting bored, or giving up. Its easy to come up with excuses to abort etc….Having the wrong person out there with you can be detrimental and a bad experience. Solo is a great way to push...
Great choice. Standard of greatness. NF no need to lap also void’s warranty for heads up. Your fix it stick will need ability for 68 inch pounds as well for hex nuts on rings to base as well. Good luck!
I use a borka torque driver, has less mechanical areas to fail or be out of spec. I would be cautious of a wheeler as it is relying on more parts to be in spec. The goal is to stretch screws but not too much or failure occurs. Personally i would use something similar to NF ultralights. Some i...
Ive extended use of 15* bag by pairing with custom down pants/booties from goosefeet. The pants i had made I believe are 0 degree/6 oz… they are so warm had to take them off in bag and ive just layed them next to me so far in temps ranging in teens. The downside to this as a multi function...