Lawnboi's latest activity

L

Lawnboi replied to the thread LRI's hard case shipping requirement.

Just be prepared, current shipping prices are stupid. That’s the nicest way to say it.

Today at 4:37 AM
L

Lawnboi replied to the thread The 22 creedmoor thread.

I’d go as short as the suppressor allows then. 16-18” seems about right. I have no regrets with my 16.5”

Yesterday at 5:53 PM
L

Lawnboi replied to the thread MKC Alternative.

Deer rock knives, he’s on here if you search. He will make what you’re looking for.

Yesterday at 5:49 PM
L

Lawnboi replied to the thread The 22 creedmoor thread.

Do you have a suppressor yet? That would be a major factor when determining length for me

Yesterday at 4:58 PM
L

Lawnboi replied to the thread Annealing causing pressure increase.

The whole point of annealing is to soften the neck and reduce/eliminate spring back as brass goes through its life. Both in shoulder...

Yesterday at 4:29 PM
L

Lawnboi replied to the thread FL size below .200” line?.

Some premium dies like your micron, and SAC are designed to size more of the case to combat the problems that can occur Reloading tech...

Yesterday at 1:38 PM
L

Lawnboi replied to the thread Custom rifle maker - recommendations wanted..

If you like the alpine you will like the manners eh1. Personally I wouldn’t buy another AG. And didn’t like how squared off the...

Yesterday at 8:45 AM
L

Lawnboi replied to the thread .223 for bear, deer, elk and moose..

I’m glad ‘gunwriters’ are no longer relevant. Now if we can do the same with the YouTubers we can get some real information out there...

Yesterday at 8:42 AM
L

Lawnboi replied to the thread Soft Padded Rifle Case for Suppressor?.

Triad tactical or Armageddon gear. Us made, they make them long as well

Yesterday at 8:36 AM
L

Lawnboi replied to the thread Annealing causing pressure increase.

Just saw this as well. If you’re not measuring, annealed cases will usually size more, due to less spring back. That’s pretty much why...

Friday at 2:03 PM
L

Lawnboi replied to the thread Annealing causing pressure increase.

Usually I anneal before sizing so take this for what it’s worth. Did it feel like the case gripped the bullet more when seating? Neck...

Friday at 1:59 PM
L

Lawnboi replied to the thread FL size below .200” line?.

Looks good, I’d personally rather have a die that sizes to the base than have to deal with a tight piece of brass.

Wednesday at 7:29 PM
L

Lawnboi replied to the thread FL size below .200” line?.

Many of the premium dies size a little farther down the case. Similar to a small base die by some of the more main stream companies...

Wednesday at 5:34 PM
L

Lawnboi replied to the thread 6CM clickers.

Some of the slower burning seem to be a little less sensitive to that odd hot round. I don’t have any science to back anything up though.

Wednesday at 5:28 PM
L

Lawnboi replied to the thread 6CM clickers.

Your clickers are probably from the brass fire in another chamber. To break it down. Each chamber may very slightly in diameter on...

Wednesday at 3:40 PM