A little update from suggestions earlier on.
-pulled bullets and definitely didn’t over charge
-picked up Peterson brass and it’s much better quality.
So I went out again and loaded some 145lrx’s up with 7828 and found an okay enough load for hunting, 3/4” group at 100 will have to do but...
Bolt was definitely stiff with blown primer and No it didn’t just back out it fell out of the pocket completely. Bolt wasn’t really stiff with other firings.
I understand crimping isn’t necessary but wanted to see what it would do for me for. For now I just full length size. Maybe one day I’ll...
Didn’t get the chance to pull bullets this evening but was thinking I do have some fireformed Hornady cases that might be worth trying. I’ve read conflicting reviews on it. Anyone have a better experience with Hornady than Nosler?
I do think I will get some Peterson brass coming, as it seems to...
Thanks everyone. I will pull bullets, double check powder and try again at a lower charge.
Also have some 145 lrx’s coming that I may try with h4831sc.
In preparation for a third season hunt I’ve been working up a load for my 280ai and the last two trips to the range have me fully confused. So I need some help understanding what went wrong. A little side note I’m still fairly new to rolling my own. I have had good success with .243, .30-30 and...
For sale is a Redding competition seating die for 280 ackley improved. Used to seat 63 bullets exactly. It’s a great die, super easy to use just switching over to the forester version. Asking $115 tyd.
If you’re willing to spend the money, buy a flat top stock and have a gunsmith inlet it for you.
If not, MPI is another options not mentioned I found in my search.
Here’s mine in a manners eh3
Mechatronics engineer here currently working in a heavy industrial manufacturing facility. Sounds like you’re mechanically inclined so an ME would be up your alley. Personally I wouldn’t worry to much about a PE. One thing is engineering will help you move up from your current position but I...
I have some 155 hunters to try. I understood the absolutes require a faster powder and wanted to see if anyone’s worked up a recipe for them. Seems like a viable option if the increase in velocity is achievable.
I’m having this same issue with inconsistency in sizing 6.5-300 wby. Below are my problems so I’d like to know what your solution was.
Brass-1x fired wby
Rcbs full length die with expander ball
Unique case lube
Using a mitutoyo caliper with a Sinclair #25 bump gage I measured a fired case and...
Bumping this thread up as I am building up components for my 280 ai as well. Has anyone tried the 160 shock hammers or heavier hammer offerings? Thinking of a 5-600 and in elk bullet.