In hopes of helping out the collective Hive Mind:
If you are annoyed that your SWFA 6x doesn't have a zero stop, try "M18" crush washers.
I specifically used M18 washers that were 18mm (id) x 24mm (od) x 2mm thick. Three of these stacked inside the elevation turret made an almost-perfect zero stop (would advance about 3-4 clicks at most past zero.)
26mm wide fit the best, but they are tougher to find.
Costs like $6 for 10. Work waaaaay better than the hose washers I was using before.
Happy MacGyvering.
If you are annoyed that your SWFA 6x doesn't have a zero stop, try "M18" crush washers.
I specifically used M18 washers that were 18mm (id) x 24mm (od) x 2mm thick. Three of these stacked inside the elevation turret made an almost-perfect zero stop (would advance about 3-4 clicks at most past zero.)
26mm wide fit the best, but they are tougher to find.
Costs like $6 for 10. Work waaaaay better than the hose washers I was using before.
Happy MacGyvering.