Recent content by Gman
-
Shooting a nanny
I took a nanny two years ago on a nanny-only tag in CO. Our genetics produce some huge Nannies and taking them is necessary for herd health. I guess it's all dependent on the area you're hunting. It was an amazing hunt and now that proud goat is displayed in my home. And it tasted great. I...- Gman
- Post #36
- Forum: Mountain Goat
-
Kuiu sleeping bags/expensive gear
This is where it's at. If you buy quality gear you most won't have to upgrade ever or if you do it will be because of a freak accident or 10 years later. For example, my WM down bag will last until the time I get too close to the fire (again), and my kifaru pack will only need to be upgraded... -
Hamskea
I'm with JD on this. By far the most bomber rest I've ever used. The adjustability is almost infinite so if you're a tuning geek -- like just about everyone on this site is -- you can really play with it until you get exactly the arrow flight you're looking for. It also comes with some great... -
Sleeping in your bag with clothes
Yes, I am BACK! And yes I'm shouting. Been busy man, but I'm ready to piddle away countless hours on Rokslide once again.- Gman
- Post #24
- Forum: General Discussion Forum
-
Credit cards and applying for tags??
I used to take out a new card every 18 months or so -- and cancel the old one when it was time -- so I could take advantage of the 0% interest for 18 months. I usually would get 2 seasons out of this. I'd pay $100 or so each month just to whittle it down and then wait for the refund checks and...- Gman
- Post #14
- Forum: General Discussion Forum
-
Sleeping in your bag with clothes
Pretty much this....- Gman
- Post #17
- Forum: General Discussion Forum
-
Bitz jig with right helical clamp
Did you shift the upper and lower parts of the jig in opposite directions with nearly equal offset? Sent from my iPhone using Tapatalk 2 -
Bitz jig with right helical clamp
Set the arrow in the jig and then place the clamp in place with a vane. Loosen the adjustment screws and slowly adjust until you get solid contact along the entire vane. Tighten it down and you'll be good to go. I started with straight and went helical and get perfect arrows after adjusting. -
-
Hamskea Versa Rest instructions?
Had to go with the deep groove launcher due to fetching contact. LOVE my versarest. I also use the arrow clip in the front of the rest and the little rubber rest on the back to minimize noise. Best rest I've ever had. -
Fletching glue
I found the number one criteria for me is the use glue with a good cap that has the pin poker on the inside to keep the tip from getting clogged. Gold Tip has this so I stopped looking there. Also tried Goat Tuff and was not impressed. -
New KUIU
Well, I fell for it and called up Kuiu to make sure my stuff didn't get lost. They explained that there was one half day where they had a computer glitch and everything was backed up on paper and assured me no orders were "lost". So all is good. No need to call in. Unless you want to. -
Featured Video
Stats
Latest Articles
-
Gunnison Mule Deer and Beyond with Brandon Diamond
-
Idaho Mule Deer Management with Eric Freeman
-
TT#28 Idaho Bear Hunting with Roger Holscher and Chris Young
-
Rockstar Research with Kevin Monteith
-
Hunting Big Mule Deer: Obey the Wind & Still-Hunting
-
TT#27 DIY New Zealand Hunting with Australian Duo Miller and Pitts
-
Fewer Bucks, More Fawns?
-
Mathews Lift Review
-
Wyoming Range Winter Wrap-Up with Jeff Short
-
The Pursuit with Cliff Gray