Stone Glacier Sky Talus 6900 on X-Curve frame with medium belt. I am asking $800tyd for the entire setup which includes the accessories listed below. The original purchase price was $926, I believe. This pack is in new condition, I bought it and a Sky 5900 and decided to stick with the 5900...
Update...I'm pretty sure the scope isn't holding zero. I have now tried 3 different factory loads, 1 Hornady, 1 Federal, and 1 Browning. Same results as my hand loads...occasionally a good 2 shot group then the 3rd shot will be off by 8 or 9". A guy next to me at the range was also shooting a...
I was worried that the Universal Gun Bearer I ordered wouldn't be here in time. I called them and asked to pay for their fastest shipping option which the CS rep said would put it in my mailbox the day before my hunt. It showed up within 3 days, and a whole week before my trip. Kifaru's CS is...
You just described my load dev method, minus the chronograph. I have tried H4350 and H4831sc, each with Accubond 180's and SGK 165's, in .5gr increments seated .015 from the lands. I then took the best groups and started experimenting with seating depth moving out to .050 from the lands. I'm...
I will ditch the lead sled. I only used it because shooting 40 rds during load development from a 300 wsm prone sucks in the recoil department.
I didn't get to shoot tonight. The field I have permission to shoot over was being plowed, so I'll have to wait until Friday.
Yeah, I normally don't worry too much about cleaning. This debacle started with accuracy issues, which led to inspection, which led to the discovery of copper streaks in the bore, which led to the cleaning.
I usually use a led sled off of a bench. I'm going out this evening with some factory...
I think my jags are brass, but it doesn't change the fact that I can still see streaks in the barrel. I did remove the scope and mounts last night. Everything looked fine but I went ahead and lapped the rings and re-torqued everything to spec. I bought some Federal blue box to try...
To answer the cleaning questions: I have tried using Wipe-Out, Break Free Bore Foam, and Hoppes Elite Bore Foam. Wipe Out seems to be working the best using the method ofl0926 described. But, all of the bore cleaners I have tried result in never-ending blue patches. Another note, I've never...
Is this copper fouling causing poor accuracy? UPDATED
I’ve been struggling for 2 weeks to work up a load with acceptable accuracy for this rifle and it’s driving me nuts! Working up from min to max loads in .5 gr increments is producing head-scratching results with accubonds and partitions...
I have one of their 0* synthetic bags. I haven't used it on any really cold nights, but construction is really good. It is Climashield Apex insulation. The only thing I don't like about it is that it is a little slim...and I'm 6'0" and 175lbs...so not a wide guy at all. Anyone much heavier...