No experience with buffalo but been put over and under fences at calving time with beef cows…adding the size and wild factors in makes it a spot I don’t want to be.
The fastest I’ve had to retreat was from a baby badger…5 pounds of pure mean
Thanks, that had crossed my mind as a problem!! I’m looking at a reusable canister to have in the cabinet but humidity hasn’t ever been too bad, never have tools rust in there
That’s a really organized setup👍. I have a bench setup in a separate workshop that should work fine but doesn’t always have heat on so won’t work for components.
Thanks for the replies, humidity doesn’t get too bad in the summer. Usually have a fan going, good to know about bottom shelf.
I snuck in the conversion to Fahrenheit…. I’m a bit north of you guys but I remember some comments about our metric system from another thread!🤣
I haven’t found a specific thread on storage so I’ll start a new one. I’m starting into reloading on my own soon and don’t have room in the house for keeping components. I have an attached garage that I keep at 46 degrees in the winter and probably gets up to 75 in the summer
Is this too much...
I’ve been using the same L magazine for 7mm-08, 7RM, and now 6CM without any feed issues. So far hasn’t made a difference whether each cartridge is pushed right back or not.