sdupontjr's latest activity
-
Ssdupontjr replied to the thread Rail and rings recommendation - Tikka T3X 300 WM.I used a mountain tactical rail with recoil pin on one with vortex precision match 34mm rings (basically seekin rings) The other used...
-
-
Ssdupontjr replied to the thread Reloading advice: bullets? Vary for target/hunting?.I use 130 ttsx and 155 lapua scenars in both my Tikkas. Have killed with both and the scenars are labeled a target bullet. Both are...
-
Ssdupontjr replied to the thread Solve this mystery.This, I did this by accident. Thought my seating die was set correctly but wasn't. The range official that I know kept telling me that...
-
-
Ssdupontjr replied to the thread Tikka Bolt Body Conversion.Just FYI, I had a Tikka T3 7mag that I was wanting to barrel swap for a 308 CTR contour. I posted on the site about a possible trade of...
-
Ssdupontjr replied to the thread Tikka Bolt Body Conversion.If the bolt face is the same size that you're wanting to go to, then simply change the bolt stop. Changing the bolt stop can make it...
-
Ssdupontjr replied to the thread Maven RS.5 - low light performance?.^^^ this. Should have elaborated more. I also have a 2.5-10x56 accupoint that my son now sports on his R700. But as KenLee mentioned, if...
-
Ssdupontjr replied to the thread Maven RS.5 - low light performance?.If low light is what your after, schmidt bender Polar T96 is king. I have a dedicated tikka 308 that is my low light setup with a SB...
-
-
SI wouldn’t say I’m an expert, but I am meticulous in my loading and always tumble a second time after resizing to get the lube off...
-
SNope Not falling for it this time 😎
-
Ssdupontjr replied to the thread Which tikka to buy.Polymer one. Ordered it from Mountain tactical. You'll also have to lightly sand the barrel channel of the T3x stock to allow the CTR...
-
Ssdupontjr replied to the thread Modern 308 bullets.My Tikka T3 Lite 308 runs the 155's over 47 g Varget at 2860, my 20" CTR runs 47.5 g Varget at 2840. I could prob use faster powders...
-
SPoint being, the 7 PRC in a Hornady loading doesn't do anything more with long, heavy bullets in the fast twist barrel, because they...
-
SI’ve never seen damage to a bullet from using the properly sized collet in my RCBS. But, I bought some pulled 160gr. Accubonds on...
-
Ssdupontjr replied to the thread Modern 308 bullets.Try the 155 Lapua Scenars. You definately have the barrel length. If you can stoke up a load close to 3000 fps, they will get you to...
-
Ssdupontjr replied to the thread 7mm Rem Mag vs the new age.You are basically confirming everything that I have been reading and have heard. I like Hornady products and have been using them for a...
Featured Video
Stats
Latest Articles
-
Idaho Mule Deer Management with Eric Freeman
-
TT#28 Idaho Bear Hunting with Roger Holscher and Chris Young
-
Rockstar Research with Kevin Monteith
-
Hunting Big Mule Deer: Obey the Wind & Still-Hunting
-
TT#27 DIY New Zealand Hunting with Australian Duo Miller and Pitts
-
Fewer Bucks, More Fawns?
-
Mathews Lift Review
-
Wyoming Range Winter Wrap-Up with Jeff Short
-
The Pursuit with Cliff Gray
-
Mile High Mule Deer Seminar