I found a box of 500 hard cast 200gr rnfp 44 mag bullets on clearance for 20 bucks and couldn't pass them up. They have a gas check and we're tumble lubed at factory.
I usually load 240gr jacketed with h110 so I have like 3.5 lbs of the h110.
Is there any way to marry the h110 with the 200gr...
I kind of agree which is why R15 seemed like a good idea. It is a bit slower. However, I cant seem to find it in stock anywhere locally. sportsmans, cabelas, scheels, local shops. I cant even find it online in stock. BAH
I want to start by saying accuracy is important to me. I understand that I can have a 2 MOA rifle, and pretty much center cross hairs and pull the trigger and get a dead deer within reasonable distances. I find chasing accuracy to be fun and rewarding.
Rifle is a 308 win, 24" criterion barrel...
the Nosler average of 3 rounds was 0.4665 +-.0005, and the federal and barnes were both .04645 +- 0.0010. My documentation shows Saami max spec for diameter is 0.473, so all rounds are well under. I was verbally told it was a match chamber, so it is tighter I believe. As long as it shoots my...
Hello, Im going to try to make this brief. I dont know if thats going to be possible... sorry.
I build / repair medical lasers for a living, I am very mechanically inclined, and have built an AR15 from the ground up, so give me the benefit of the doubt here that I know what I'm doing a little...
Yes, it's a guide dcs jacket.
As for inseam...
Kuiu inseam on standard pants are all advertised as 34 inches. Measuring them that looks right. FYI, the tape in the picture starts about 2 inches because it's for measuring your waste. I find it easiest to measure from 10 inches. The inseam is...
For the XLL jacket alone, asking 180$ TYD
For the size 38 Pant alone, I am asking 125$ TYD
For the set, I am asking for 280$ TYD.
bought a Vias Guide jacket and pant set last year after my deer hunt. I wanted a color that does better in the sagebrush and dirt than the verde I was using...
Im thinking of picking up Quickload or something similar, but have a question that has to do with cartridge length. I am doing my seating check with my hornady comparitor which measures where the ogive touches the lands to the bottom of the brass. I then minus 0.010 to the length and thats...