Eventually the Rokstok will be inlet for the M70. Right now, the Stocky's VG seems to be a very good option. They should be available now. I don't see it on the website, but I haven't fully deciphered their new website yet.
I am not sure. I do not do the 30 shot group thing. I do all my load tuning at longer distances (600 - 1000 yds), and at longer distances three-shot groups tell you the truth about your load. I have a stack of targets with with sub 1/2 MOA 10-shot 1000 yd groups (shot in competition) that I...
We are set up as a dealer. We are planning to stock Tikkas. Still working out the details on all that.
The idea is you can get your Tikka from us, then accessorize it if you want with a threaded muzzle, brake, rings, our bottom metal (still in development), cerakote, Rokstok, etc; then we...
There are lots of ways to find loads. However, we have to separate load development from POI shifts due to conditions. We frequently miss changes in conditions at long range. Everything may look the same, but they most assuredly are not.
There have been times I have watched the wind flags...
338 Edge +P seems to like 4-5 grains more H-1000 than a standard 338 Edge. So instead of 91-92, the +P will probably like 95-96ish. As always, start low and work up.
That is NOT consensus. Three-shot groups to find loads at long range tell you a lot. Using three shots groups at 1000 yds has allowed me to repeatedly shoot sub 5" 10-shot groups at 1000 yds in LRBR competitions. A couple matches ago, over two days, in varying relays and conditions, I shot...
Currently, with the Wheeler chamber, if you get clickers you know it's most likely either a hot load, an out of spec die, oversize brass, etc. You know it's not likely an undersize chamber. I am sure the standard PRC chambers were fine at first, nominally .004 to .005" over the size of new...
Well, we kinda have already seen it works without clickers............though I am sure someone can load even a Wheeler chamber hot enough to get clickers.....................
I hear that some on the forum think that the only way to get repeatable results in load development is to shoot multiple 5+ shot groups at 100 yds. That method can work--I won't argue that. When I was using that approach I did everything at 200 yds and it worked okay. However, let me explain...