300 wsm powder of choice?

[Paisano]

I'm looking at starting load development for a 180 gr accubond for my 300 wsm. The gun is a CA ridgeline with a 24 inch barrel. What temperature stable powders have guys had good luck with? Thanks!!!

 

[MidGAHunter]

My CA Carbon Classic in 300 WSM with Barnes 180 grain TTSX and Hodgdon H4831SC shoots 1 ragged hole at 100 yards and easily holds sub-half MOA at 300 if i do my part.

 

[ShortMountain91]

Following. Got some H4350 and 180 gr accubonds but haven't loaded any yet

Sent from my SM-G950U using Tapatalk

 

[wind gypsy]

H4350, RL16, H4831sc

Probably in that order.

 

[Dexter Grayson]

Hybrid 100V

 

[idig4au]

RL17

 

[Coulee Kid]

H4350 worked the best for me

 

[MillCreekMike]

I'm doing good things with H4350 & 165 grain Accubonds in my Browning Xbolt

 

[wilydawg]

H4350 as first choice
H4831SC as second...

 

[CAhunter]

H4831sc works well for me with that bullet

 

[worx53]

I have 4 -300wsm rifles-couple were finicky for sure but they all liked 63 grains of winchester 760 , 175 grn barnes bt long range, and federal mag primers

 

[BJP]

H4350 , rel 17, then h4831 tried 180 accubonds and 185 berger classic hunter the bergers shot 1/4 moa better than accubonds. Pushing them to 3086 fps with h4350

 

[HiMtnHntr]

I have found RL 17 to work great.

 

[Sekora]

H4350 with the 180 grain Accubond for me seated deep. 4831SC for the heavier bullets.

 

[MillCreekMike]

I think I'll try RL17 next.

 

[JP100]

I use AR2209 which is good in a shorter barrel, its the same as H4350.
am using 63.5 grains with the 178gn eldx for about 2950fps from a 21" tikka



H4831/AR2213SC will probably give you better velocity in a longer(24"+) barrel.

 

[Iman]

H4350 worked great for me

 

[xcrunner805]

H4350 with 190 gr Berger vld or 180 Accubonds work well for my Christensen Arms 300 wsm carbon one hunter (the original CA model)

 

[JLW66]

H4350 for me with Hornady 165 GMX. I started to run a test with Hybrid 100V, but got immediate pressure signs (sticky bolt) with my starting load out of the Nosler Manual. Very odd. I am in the process of rechecking my process. The Hornady manual Max load was much lower. Just saying if you are going to use the Hybrid 100V and the Nosler Manual start alittle lower than usual and move up slow. I was using 180 Accubonds for my test.

 

[Hnttillmt]

Another vote for h4350. Barnes 168ttsx @3150 fps has been a wicked game getter.