Bow Tuning & Set up - Rest Placement

[wildernessmaster]

Put in nock points and d-loop so my arrow at 90 degrees is center on berger hole.

When I baseline my arrow rest, I know I want to center shot it, but as far as the fall away portion of the rest should it just touch the arrow nocked at 90 degrees or what?

 

[X-file]

What kind of rest? Some will be slightly angled forward. Others will be straight up. A ripcord will position differently than say a limb driver.


Sent from my iPhone using Tapatalk

 

[journeyman713]

Set up the rest and nock the best way you can figure, but know this step is just a rough alignment.
The next step, Paper Tuning, will help you fine tune your alignment with confidence.

 

[Brendan]

Rest up in shooting / full draw position is starting point for all measurements. If it's limb driven - that means removing the cable. I prefer centershot as arrow running dead down the center of the limb bolts when viewed from above.