DIY Bino Harness

[philintheblank]

Been looking at the FHF gear harness for a while, but my inner cheapskate wouldn't let me pull the trigger on one.

I cobbled this together mostly from scraps I had laying around already. Had to get a couple ladder locks from the local sewing shop. At some point I will make a new black webbing harness for it, but for now the donor harness from an older one will get me started.

 

[AZ_Five56]

It looks pretty great for something you cobbled together! Well done!

 

[philintheblank]

Should probably add a bit more description on this build.

The material was left over from another project.

The webbing and edging was mostly pieces cut off of retired kids stuff and other gear.

The clasp is made from 1/16" stainless welding wire.

The mesh pockets were cut from an old storage bag.

There is some 1/8" craft foam (EVA) from the kiddos craft bin between the fabric layers to give it some structure and padding.

Moral of the story is if you hoard enough junk, eventually there is something useful in the pile.... at least I tell the wife that.

 

[feanor]

Nicely done!

 

[couesbitten]

You should "cobble" more often, well done!