Hand Made Euro Plaques

[Stubborn_bowhunter]

Spent a lot of last week grinding out some variations of a euro mount plaque I fabricated a couple years ago.
Thought you guys might appreciate them.
This is the original one from a while back..


These the new ones.

 

[Stubborn_bowhunter]

 

[BRTreedogs]

Nice man.
I need to build a couple.
How long is the mount for the Elk ones?

 

[Stubborn_bowhunter]

Nice man.
I need to build a couple.
How long is the mount for the Elk ones?

I have them right around 8", but found with the bigger bull 362" the brain cavity hole is bigger.
So the blue one doesn't hold it properly because the supports are too far forward.
If I do more I'll probably weld the support further back, so the brain cavity rod can go into it further.
I took these photos to remember where the prongs were. Moving it back an inch on the green one would probably be a lot better.

 

[BRTreedogs]

Great thanks.
I'll start there.

Last one I tried it was way to short to hang on a wall because I couldn't rotate the antlers back.