What was your muzzle thread pitch? I have a t3x lite in 7mm rem mag, but the muzzle at 24" is too thin to have any shoulder left. , would need to chop down to 22" at least as well to thread anything
22 creedmore in an ag stock
Will be raffled in a few weeks.
Is there enough meat at the muzzle to thread 1/2x28? For suppressorYes I have been shooting 75 ELDM out of my 1:8 twist tikka 22-250 for almost 2 years now.
Loaded to 3380 fps speed has been very accurate even to steel at 1k. It worked great on 3 deer this fall with ranges from 320 to 420 yards.
Do you have a recommendation on a shop to do a cut and thread in the anchorage/matsu area?I did on mine. Bushing up to 5/8x24 so I can use my 30 cal suppressors.
How'd you get Hawkins 35mm single piece rings?! I want some........only reason I haven't gone mk5hd.Got this one in, 6.5 saum from hells canyon armory.
Just got our tikka hybrids opened up to 35mm for the leupolds as well as the other 35's.
We will have them soon on the www.bertrambrass.com website, we are having our 34mm converted/opened up my a machinist that made a fixture and all. We were testing to make sure the rings worked with the scope 1st before we had a bunch done. Once i have a few sets ready i will post on the site. Extra machining done will cost a bit more.How'd you get Hawkins 35mm single piece rings?! I want some........only reason I haven't gone mk5hd.
We will have them soon on the www.bertrambrass.com website, we are having our 34mm converted/opened up my a machinist that made a fixture and all. We were testing to make sure the rings worked with the scope 1st before we had a bunch done. Once i have a few sets ready i will post on the site. Extra machining done will cost a bit more.
As soon as orders are made. We have 30's on hand low and high
Steve at Alaska Custom threaded mine for an Area 419.Do you have a recommendation on a shop to do a cut and thread in the anchorage/matsu area?