Mission switch string/cable photos

[WI in the west]

Can somebody woth this bow put pictures up of the strings and cables and how they run through the slide? My girlfriends bow got derailed and i cant for the life of me figure out how the cables run past eachother. It seems no matter how i do it they are touchingat some point. Not sure of the new plastic slide piece is wrong otherwise to cause i bought a new one that should have been for them but maybe its wrong. Thanks

 

[Billy Goat]

Here's a few pictures I found with google.

 

[WI in the west]

Thanks, i tried googling a few dofferent ways but never could find any pictures that were clear enough to tell what or where anything is, it looks like our new plastic slide is not right though for sure

 

[Billy Goat]

As long as the slide is close in design and doesn't allow the cables to sit closer than factory it will still be alright I suspect. Looks to me like any Hoyt slide would work. The Elite slides would fit as well, but they seem to be pretty hard on cables. I always swapped them out.

 

[WI in the west]

What would you swap to? I think what i was goven is wrong because the cables always touch relativley sognifacantly, maybe its at 3/4 draw they start to hit and hit harder all the way back or they slide along eachother until you hit 1/4 draw. I think ive tried every way to arrange the cables with no luck so im leaning towards its the slide

 

[Billy Goat]

Are the cables run correctly? I'm assuming if it derailed you didn't need to do anything but put them back in the groves. If you took off a yoke or an end loop it's possible you accidentally put them on in the wrong order. The slide is offset from center, sitting towards the top, so the top yoke cable needs to sit further off the slide. That's orienting the slide so the shorter groove is in the front or towards the bow, the long groove facing the archer.

 

[WI in the west]

Im leaning towards its the slide, heres a few pictures of what i got goong on with the one given to me from a dealer curious if you see anything wrong

 

[Billy Goat]

I'm not seeing anything wrong.
The slide on the ones above do look a little different, but I would have thought most would work. I guess I was wrong.

 

[WI in the west]

Yeah it sees it makes the cables cross closer to the bottom can which is maybe why they are hitting, hopefully thats it ill see and post once i get the correct piece so other poeople that search this can see.

 

[WI in the west]

In case any one else has the same issue that plastic slide piece fixed the cable contact so it must be dofferent enough to cause an issue