Prime Black 3 Initial Setup and Nock Height

[PhillyB]

Hi all- I just picked up a brand new Prime Black bow.
I was reading through the owners guide and it says to set nock height 2” above center.

I am curious if this means to center the arrow over the Berger hole, set the arrow to 90* on the string, then measure 2” high from the center mark to find the nocking point?
I included a pic of the owners manual below.

I have setup and tuned a lot bows, but this is my first Prime.

Any input is welcome. Thanks

 

[Rob5589]

Is 2" at or near the Berger hole?

 

[Jimbob]

Probably means find the center point between the cams then go up 2”


Sent from my iPhone using Tapatalk

 

[OR Archer]

Just set it 90* through the center of the Berger hole

 

[Billy Goat]

Seems to me they are saying 2" above the string center. I'm betting that puts you right thru the Berger hole at 90.

 

[Ucsdryder]

Yep. Put in a vice. Find the center of string by measuring axles and dividing by 2. 2” high and through Berger.

 

[chadwhit]

How are you liking your prime?

Sent from my GM1917 using Tapatalk

 

[PhillyB]

Thanks guys. Set it up like I normally would and it worked out perfectly.

 

[PhillyB]

How are you liking your prime?

Sent from my GM1917 using Tapatalk

So far so good. The valley and the let off are incredible.
I haven’t been able to spot any arrows at distance, but it tuned up well.

 

[Elkhntr08]

Just set it 90* through the center of the Berger hole

This ^