Proper way to attach Grab it to a Shape Charge?

rcb2000

WKR
Joined
Dec 20, 2017
Messages
392
Location
Virginia
Hi Roksliders,
Any help on the correct way to attach a grab-it to a Shapecharge? The good folks at Kifaru recommended I get slotted female SR buckles and Male autolock buckles.
So this is what I have.
2D825BCD-E9A9-4ED6-969C-53C19059D9B7.jpeg

I tried just fitting the buckles on the top onto those loops, but something tells me that’s not correct.
697048E7-20CD-441F-9080-5189F3BBF7A7.jpeg



For the bottom connection I could either do the same with the buckles, or use two k-clips and thread the strap through them after connecting to the loops on the bottom?

Any advice is much appreciated
Thanks
 

Kaylee_F

FNG
Joined
Dec 13, 2019
Messages
1
Location
Denver, CO
You'll want to run the autolock male/slotted females on the bottom straps of the grab it to connect it to the bottom of the pack and then run the top straps to the tab you have it connect to in the bottom photo.
You could use a k-clip to run the bottom strap through (connecting it to the bottom of the SC) and back up to the tensioners like they were designed. Either way should work.

-Kaylee
[email protected]
 
OP
rcb2000

rcb2000

WKR
Joined
Dec 20, 2017
Messages
392
Location
Virginia
Thanks so much Kaylee.
I’d also like to mention how helpful everyone at Kifaru is, super fast responses and easy to talk to.
Frank responded to an email I sent to the customer service address within an hour.
FEBE21CB-B7CD-4248-8BBF-CF8E6E612F5F.jpeg
 
Top