Rest and Quiver adjustment?

[Jacob Chapman]

I have a Mathews V3 31, Hamskea Trinity Pro rest, and Tightspot quiver.

For some reason I can't have my Tightspot mounted flush on the attachment part that goes on the sight bracket deal, because if I do then the bottom bracket of the quiver (where the arrow holders are) hits the outside adjustment knobs of the rest.

I'm sure i'm doing something wrong/it was setup wrong from the shop-any ideas?

Have to believe there's some other way of setting up the quiver bracket that allows me the space I need.

Thanks-

 

[sndmn11]

Did you try flipping the mounting bracket around so the L part points out?

 

[Billy Goat]

That hamskea is just a big rest, can't get a quiver but so tight to the bow with it.


The mounting bracket can be mounted either tab in or tab out, if you have the clearance.

 

[Jacob Chapman]

Did you try flipping the mounting bracket around so the L part points out?

I'll give that a try, haven't played with it much.

 

[coyotecreek]

When I had my V3 (gladly sold it and bought a Solution) I had to angle the quiver with the fletching back towards the string to get the clearance I wanted. Might be something to try.

 

[bojangles808]

This was how I had mine set up and I think it's just like your setup. I have the mount flipped to get it closer to the riser. Perhaps with my hha sight it mounts a little further back so I can get clearance if mounted vertically. On my backup bow I have it angled to clear the rest similar to what coyote creek mentioned