sabotloader
WKR
I was able to get out to the farm this morning and get some shooting in before the heat began to rise.
This new Lehigh is made from s7 tool steel and is a very tough metal. In the previous post I mistakenly labeled it as 17-4 Stainless
Today project was to test fire the new Nipple with a BP sub powder.
The nipple performed really well and it was fun to shoot with it. But... If you have seen the previous post:
www.rokslide.com
In that post I showed how tight the CCI #11 and RWS 1078+ caps fit the nipple post - providing a water tight seal between the post and cap. There can be a negative side to this tight fit also. Anybody that shoots caps understands how dirty the Nipple and the Breech becomes. I found that after 5/8 shots with a Magnum caps the nipple post became so dirty the cap may not seat on the post correctly. Wiping the post with a damp patch cleared the problem very easily.
Here are a couple of composites of the shoot this morning....
This new Lehigh is made from s7 tool steel and is a very tough metal. In the previous post I mistakenly labeled it as 17-4 Stainless
Today project was to test fire the new Nipple with a BP sub powder.
The nipple performed really well and it was fun to shoot with it. But... If you have seen the previous post:
Just so Know - Testing a new #11 Nipple
I have to correct an error that I made... The nipples are not made of 17-4 SS but rather S-7 steel which is a more resilient metal S-7 is an air or oil hardening tool steel that is characterized by very high impact toughness. The combination of strength and high toughness makes S-7 tool steel...
www.rokslide.com
In that post I showed how tight the CCI #11 and RWS 1078+ caps fit the nipple post - providing a water tight seal between the post and cap. There can be a negative side to this tight fit also. Anybody that shoots caps understands how dirty the Nipple and the Breech becomes. I found that after 5/8 shots with a Magnum caps the nipple post became so dirty the cap may not seat on the post correctly. Wiping the post with a damp patch cleared the problem very easily.
Here are a couple of composites of the shoot this morning....
