Torque value on NF zerohold (2 inch pounds...really??)

[nrh6.7]

Quick question for those with the 4-16x42 atacr. The zero hold adjustment calls for 2 inch pounds, so for those that have had this scope did you just tighten by feel or did you actually buy a torque wrench that goes down that low? NF seems to be the only place that sells a 1-10 inch pound wrench. Borka has the 4 inch pound socket but not sure I want to double the specs.

Looking for advice on this. Should I go ahead and order the kit from NF or go by feel? Any other source to buy?

 

[nrh6.7]

Should have been more specific. Its the elevation screw specs for the zero hold turret, not the elevation cap, which is 10 inch lbs. The zero "stop" versions say torque to 4 inch lbs., but the zero hold says 2.

Page 13
#5.