Xpedition xcursion 6
29” draw
70# limbs maxed out (I don’t have a scale)
Shooting:
29” Easton axis 260, x hit inserts
125 grain FP
Archers Advantage says this is optimal
This is my first time trying to tune this bow. I put new Twisted X strings on and have been struggling to get a nock low tear out paper tuning. ATA and brace height are both good, draw stops seem to be in the correct position (I’ve just been looking in a mirror since I don’t have a draw board.)
I cannot get rid of a low tear. I started with a level arrow for my nock point, but now my rest is all the way down and my nock point is 3/8” high. I’ve put twists into the control cable and taken them out, 3 twists each way. It started as about a 2” low tear but I have it to about 1/2” now. The only thing that seemed to make a difference was moving the rest. What am I missing?
29” draw
70# limbs maxed out (I don’t have a scale)
Shooting:
29” Easton axis 260, x hit inserts
125 grain FP
Archers Advantage says this is optimal
This is my first time trying to tune this bow. I put new Twisted X strings on and have been struggling to get a nock low tear out paper tuning. ATA and brace height are both good, draw stops seem to be in the correct position (I’ve just been looking in a mirror since I don’t have a draw board.)
I cannot get rid of a low tear. I started with a level arrow for my nock point, but now my rest is all the way down and my nock point is 3/8” high. I’ve put twists into the control cable and taken them out, 3 twists each way. It started as about a 2” low tear but I have it to about 1/2” now. The only thing that seemed to make a difference was moving the rest. What am I missing?