Not sure who’s feeding you that BS, just ordered a 10oz can on Amazon, will arrive Friday. Was at Cabelas last week and the shelves were full.
Are you in Canada?
No. Oregon. Most liberal state in the nation!
I do this as well, but tumble in white rice for about 1/2 hour immediately after sizing. It absorbs all the lube and brass comes out clean enough for me, but it does require a little extra attention making sure primer pockets and flash holes are clean before priming.. Lol.
What mthuntr said. Put them in a ziplock bag Spray 4-6 good pumps,roll them around in the bag, put them in the loading block to let the alcohol flash off, I usually let them sit 5-10 minutes but you don’t have to, and begin sizing. I rinse the lanolin mixture off with dawn and hot water. Works great and is a lot cheaper plus I haven’t stuck a case since I started using it several years ago.
When doing volume loads I use the Lanolin/Heet mixture and when I am doing my match loads I use Imperial Sizing Wax . I don’t think it matters as all they are doing is lubing the case but Imperial sure is slick. That small tin will go a long way.
That’s a common issue if you have used a different case lube/wax. Clean your dies and you will probably be good.
