Tikka 22-250 8 twist - 80 grain bullets and up?

270quest

WKR
Joined
Jan 31, 2017
Messages
629
Location
Boise, Idaho
For those that have played with them - did you have much success shooting bullets heavier than 75 grains? I am thinking of buying one and making whatever tweaks I may need to the bolt stop and magazine to load and shoot 80 grain bullets - assuming they will stabilize and shoot.

I want to take a T3X stainless - cut it to 20", thread it, 5" suppressor, and setup a dedicated winter wolf/coyote rifle.
 
Joined
Jan 26, 2017
Messages
2,712
Location
PA
quite a few dudes using 8 twist 22/250's or 22 creeds to shoot 88 eldm - it'll kill stuff way bigger than a wolf.

 
OP
270quest

270quest

WKR
Joined
Jan 31, 2017
Messages
629
Location
Boise, Idaho
Oh I know all about that 223 thread, and fully understand what a 22-250 will kill, but beyond that I am not on board with just hunting with a 223 - not against or disputing the results for the guys that do - just not my thing.

I'll keep my 6.5s and 7's for the deer, elk, etc.

But for a long range wolf/coyote gun, an 8 twist 22-250 slinging 80s or 88s if they stabilize, would be pretty good stuff.
 
Joined
Dec 4, 2018
Messages
2,291
I had a tikka 1:8 22-250 rechambered into 22cm. Stabilizes the 88 eldm just fine and I’m near sea level.
 

Wrench

WKR
Joined
Aug 23, 2018
Messages
5,668
Location
WA
Oh I know all about that 223 thread, and fully understand what a 22-250 will kill, but beyond that I am not on board with just hunting with a 223 - not against or disputing the results for the guys that do - just not my thing.

I'll keep my 6.5s and 7's for the deer, elk, etc.

But for a long range wolf/coyote gun, an 8 twist 22-250 slinging 80s or 88s if they stabilize, would be pretty good stuff.
My 8tw 223ai has killed yotes in the 700's with 70 and 80 gr noslers.
 
Joined
Dec 4, 2018
Messages
2,291
Did you have to make any adjustments with the bolt stop? Longer magazines?
No. Regular M short action mags. This is with a standard 22cm reamer. Ideally it would have longer freebore for the 88eld but it’s working fine as is.
 
Top