Tod osier
WKR
if the neck inside is sized to .002 below bullet diameter, how much grab is there? In other words, how much force is needed to move the seated bullet? Can it be pushed into the case with firm pressure? A lot of people are shooting for .002 (or .001), I assume that is a hunting ready "tension": waterproof and damage resistant. I have not read how tight the bullet is after seating.
My neck is measuring out at .002 under after using a lee collet die (using calipers to measure I'm getting consistent measurements). The grab isn't what I would consider great and pushing in on a bullet it slipped deeper. Are my expectations too high for a non-crimped round? Anyone have guidance as far as a way to express how tight the bullet should be? I can't grab it and twist it out, but I can push it in further after seating with good pressure that doesn't destroy the tip.
Ammo is shooting very well, so I'm really happy there.
My neck is measuring out at .002 under after using a lee collet die (using calipers to measure I'm getting consistent measurements). The grab isn't what I would consider great and pushing in on a bullet it slipped deeper. Are my expectations too high for a non-crimped round? Anyone have guidance as far as a way to express how tight the bullet should be? I can't grab it and twist it out, but I can push it in further after seating with good pressure that doesn't destroy the tip.
Ammo is shooting very well, so I'm really happy there.