Fletching Easton Injexion's

[Gremlin]

So i decided to move to the new 4mm Easton Injexions for this hunting season. I think there great but I personally thought they were a smig loud so i ordered dozen shafts and fletched them with the AAE max stealth's and i'm having issues with getting them to stick to the wraps. Idk if i'm not cleaning the arrows, wraps, or veins properly but after shooting one arrow once or twice the veins end up getting striped off from another arrow if is super close. (note i'm using a Bitzenburger jig) so wanted to see if anyone had any suggestions or has had the same issue.

 

[dangerousD]

What glue are you using? I find that the AAE Max Bond glue works great for their vanes. I had trouble with other glue and AAE vanes.

 

[OR Archer]

Like was mentioned use the Max Bond glue and the primer pen they sell. Should solve your problem.

 

[charvey9]

I get pretty good results with blazer bond on bare shafts (no wraps).

 

[Gobbler36]

I use wraps with my max stealths and impact tough Krazy glue with no issue, make sure you are cleaning shaft then install wrap and take a cotton ball with a little alcohol and clean the wrap, primer pen then small line of glue

 

[d3ntalbliss]

Green top gorrilla glueuas worked well for me.

Sent from my Moto G (4) using Tapatalk