Recently purchased a Hamskea Hybrid Hunter Pro Micro. I really like the rest so far, however I am having issues with my fletching contact on the arrow launcher when shooting. I had the rest installed at a local archery shop, then after shooting it a while noticed marks on both the fletching and launcher. I brought it back to the shop and they were still not able to correct the issue.
I should preface this by saying that before varying the activation cord location I did adjust the slack to loosen and tighten the activation cord and found neither helped with fletching contact so I ruled that out prior to moving forward.
I was able to eliminate fletching contact by moving the cord further towards the limb pocket (Roughly 3.5" from the limb tip), and lowering the rest height to 3 notches from the top.
My issue is that although I now have no fletching contact, I am getting a high tear when paper tuning. I then moved the rest up two notches to remove the high tear and no matter where I place the activation cord or vary the slack in the cord I still have fletching contact. It is as if there is a sweet spot with 3 notches down from top and 3.5" from limb tip for the cord and it won't contact the fletchings, but anywhere else for rest height or limb activation chord location and I see fletching contact..
FYI I am shooting a 2020 PSE Brute NXT and Easton 4mm Axis Pro Long Range Match Grade Arrows with AAE Max Hunter Vanes (4 fletch). I have varied the nock to make fletchings resemble an "X" and not a "T" and that didn't seem to help matters any. I am using athletes foot spray to verify contact.
Any help with this matter is greatly appreciated, thanks.
I should preface this by saying that before varying the activation cord location I did adjust the slack to loosen and tighten the activation cord and found neither helped with fletching contact so I ruled that out prior to moving forward.
I was able to eliminate fletching contact by moving the cord further towards the limb pocket (Roughly 3.5" from the limb tip), and lowering the rest height to 3 notches from the top.
My issue is that although I now have no fletching contact, I am getting a high tear when paper tuning. I then moved the rest up two notches to remove the high tear and no matter where I place the activation cord or vary the slack in the cord I still have fletching contact. It is as if there is a sweet spot with 3 notches down from top and 3.5" from limb tip for the cord and it won't contact the fletchings, but anywhere else for rest height or limb activation chord location and I see fletching contact..
FYI I am shooting a 2020 PSE Brute NXT and Easton 4mm Axis Pro Long Range Match Grade Arrows with AAE Max Hunter Vanes (4 fletch). I have varied the nock to make fletchings resemble an "X" and not a "T" and that didn't seem to help matters any. I am using athletes foot spray to verify contact.
Any help with this matter is greatly appreciated, thanks.