WTS/WTT John Deere XUV855M S4 Diesel Beast!

[dtripp0825]

SOLD..... Moving to AK. due a few months, builders did not do the shop door for the side by side large enough ( about two inches too short 6ft door). My loss is your gain, this thing is in great conduction, super low hours. Upgraded by a company called IA, has Heat and A/C, can alone was over 9k before installation. Comes with lots of additions, 4500lb Kolphin winch, ligting,new bumper, dual battery and much more. 25kobo, can meet to some extent ( or AK.) serious inquiries only! Text or call Dennis at 302-258-8279

Sent from my iPhone using Tapatalk

 

[dtripp0825]

Bump!

Sent from my iPhone using Tapatalk

 

[Clarktar]

Bring that thing to AK!

Sent from my SM-G973U using Tapatalk

 

[GotDraw?]

Why not see if you can heavily deflate your tires to perhaps 4-5psi to pull it in the garage and keep it?

 

[dye7barrel]

Where is machine located?

 

[dtripp0825]

Why not see if you can heavily deflate your tires to perhaps 4-5psi to pull it in the garage and keep it?

I may do that, deflates then today, it's at 5"11 and some
Change without the lights and rack but it may fit. thanks much


Sent from my iPhone using Tapatalk

 

[GotDraw?]

I may do that, deflates then today, it's at 5"11 and some
Change without the lights and rack but it may fit. thanks much


Sent from my iPhone using Tapatalk

Take me for a hunt some time if it works!
JL

 

[GotDraw?]

Oh-mannn! Soo close!

Drop tire pressure to 2-3lbs and see if the beads stay on to pull it in/out. Also, look for slightly lower profile (lower overall height) tires.

Also-- use thinner trim molding for the top strip of doorway. You might get another 3/8-1/2" of clearance.

Best,

JL

 

[GotDraw?]

Also- looks like you have a significant 2" lip in floor transition from driveway into the garage.
If so, grind/cut two 12" wide channels into it for about 18" deep into the garage.

When you move, mix up concrete patch with acrylic bonder and patch them up. Voila!

JL

 

[dtripp0825]

Where is machine located?

It's in WA. State at the moment. Shipped it from VA. Originally


Sent from my iPhone using Tapatalk

 

[MightyMatt]

Take 4 ratchet straps and use them to compress the suspension on all 4 corners. Should get you several inches lower.

 

[dtripp0825]

Y


Sent from my iPhone using Tapatalk

 

[dtripp0825]

Bump, bottom price 22,000


Sent from my iPhone using Tapatalk

 

[neverquit]

Run the winch under to be back axle, run the winch until the suspention is compressed enough to fit. Are used to get my jeep rock crawler in and out of my garage like this every time.