Spot Hogg Double pin

[406unltd]

I’ve been running one the last three years. The way I’m running it I can shoot out to 60 before having to move it. My arrow is going 273-275 so I set the top pin at 40. Then I aim low at the elbow/heart of an elk for every shot 0-35. This gets the arrow up into the vitals and gives me a prominent feature to aim for on a bull and consistent point of aim for everything under 40. Then below my 40 I have a white nail polish dot for 45. After that it’s my second fiber for 50, and another nail polish dot just above my bubble that is 60. Kinda redneck but it’s a simple, affective way to circumvent the problems of a single pin.

 

[V-TRAIN]

it depends on what bow you have if you need 2 blocks on the inside. on my PSE Evolve 35, NXT 33 i need 2 b/w the scope and the bracket, on my bowtech i just need 1. all the blocks on the left side of the bracket are not needed. i just had them and didn't want to order shorter bolts, i couldn't find any local had to order them.
it is rock solid the way i have it, but looks kinda crazy.

 

[MHB]

Thank you for the pictures V-Train. I may have to try this route.

Matt

 

[V-TRAIN]

no problem, if you only have to use the one block (that comes with the sight), then you won't need anything additional, the stock bolts will be fine. if you get the newer trophy ridge peak, make sure it is the cheaper version, they make a more expensive version with react technology. the one with react, you can't adjust each pin separately. you can get the peak on ebay for about $70-$80.