The 22 creedmoor thread

[Dan Carey]

I saw that, pretty pricey.

 

[mighteywhitehunter]

After a 7 month wait my rem-age barrel is on the build list and will hopefully be in my hands by the beginning to middle of November. Looking forward to shooting it, it will be 20in sporter contour, 1/7 twist with Saami Freebore. Hopefully it is a shooter!

 

[justin davis]

I saw that, pretty pricey.

The bullets pricey?

 

[Dan Carey]

The bullets pricey?

I think 35 cents a piece plus tax and shipping is pricey. Looks somewhere near 40 cents. May be alright if you only shoot a couple now and then. I shoot thousands of 22 cal a year.

 

[justin davis]

I think 35 cents a piece plus tax and shipping is pricey. Looks somewhere near 40 cents. May be alright if you only shoot a couple now and then. I shoot thousands of 22 cal a year.

Yea that makes sense. They are cheaper than the betters I have been using though. But I only use my gun for just hunting with a for a little practice mixed in.

 

[nm.otter]

I saw that, pretty pricey.

High CC & insurance fees, but perhaps worth mailing a check for these?

 

[mtnbound]

Figured I would give the 88’s a go. I think my barrel likes them.

 

[amassi]

80 eld- x
This pbb is 1:8 and saami throated (quite short)
24” its been finicky with the 80 eld x&m
Once fired Peterson large rifle primer brass
Fed 210M
45.9gr Reloder 26
2.650 COAL
3471 FPS

Sent from my iPhone using Tapatalk

 

[Smokinyotes]

That’s quite impressive. I was using 85.5 Berger’s with 45.5 gr of R26 and velocity was great at 3370 but my chamber is also short throated. 2.670 to the lands. They shot pretty good when jammed .030 into the lands but it was tough closing the bolt. Backed them off to 2.665 and the groups are only about an inch.
Loaded up some 77gr tmk with N560 and will shoot them tomorrow. If I’m not happy with the results I’m going to get it ghosted out about .050.

 

[wirehead]

Got a 1-7.7 twist 224 Bartlein barrel on the way… it’s replacing a 1-12 twist 22-250 on a R700. Will be for deer, etc. I’ve got 22-250 Lapua brass and dies. Is it worth the cost to bump up to 22 Creed or stick with 22-250 and save a few hundred bucks?

 

[swavescatter]

Got a 1-7.7 twist 224 Bartlein barrel on the way… it’s replacing a 1-12 twist 22-250 on a R700. Will be for deer, etc. I’ve got 22-250 Lapua brass and dies. Is it worth the cost to bump up to 22 Creed or stick with 22-250 and save a few hundred bucks?

I've never seen another caliber so hit and miss with accuracy. Each barrel seems picky with 88's, 80's, etc.

When I burn my barrel out I'll be thinking long and hard about a 22GT. Seems like that might be the sweet spot for case capacity, medium fast powder and heavy bullets.

 

[HighUintas]

What's the consensus on rechambering a Tikka factory barrel to 22cm? Is the barrel life as good as prefits and shoot as well? Worth doing?

 

[T_Widdy]

What's the consensus on rechambering a Tikka factory barrel to 22cm? Is the barrel life as good as prefits and shoot as well? Worth doing?

On a blued barrel, the chamber rusts very quickly if used in wet environments. Other than that mine have shot well.

 

[NoDakhunter]

Assuming you’re starting with a fresh barrel I would assume barrel life is the same. I’m 200 rounds down my tikka rechambered 8 twist and have no regrets.

 

[Smokinyotes]

77 gr TMK’s with 45gr of N560 seems to be the ticket for my short throated creed. Velocity was 3413, no pressure signs and groups right around 1/2”.

 

[wirehead]

I've never seen another caliber so hit and miss with accuracy. Each barrel seems picky with 88's, 80's, etc.

When I burn my barrel out I'll be thinking long and hard about a 22GT. Seems like that might be the sweet spot for case capacity, medium fast powder and heavy bullets.

Is that a 22 Creed problem or ELDM problem?

 

[Castle Rock]

What's the consensus on rechambering a Tikka factory barrel to 22cm? Is the barrel life as good as prefits and shoot as well? Worth doing?

Tikka barrel steel is very good, I would expect at least as much or possibly more longevity than a run of the mill prefit.

 

[mxgsfmdpx]

What's the consensus on rechambering a Tikka factory barrel to 22cm? Is the barrel life as good as prefits and shoot as well? Worth doing?

Yes.

 

[Miflatlander91]

What's the consensus on rechambering a Tikka factory barrel to 22cm? Is the barrel life as good as prefits and shoot as well? Worth doing?

I’ve been around 2 22-250s rechambered to 22 creeds both shoot very well mine has over 700 rounds through it and still shooting both stainless barrels


Sent from my iPhone using Tapatalk

 

[swavescatter]

Is that a 22 Creed problem or ELDM problem?

Great question. Seems the bullets are the common denominator and seem very picky...