A while back I was kicking around the idea of putting together a Tikka in 280Ai.
Well, I finally pulled the trigger.
Thus far here is where I'm at.
Started life as a T3 stainless in 30-06.
Scavenged a T3x stock, added the OE vertical grip, Limbsaver, & a Rustoleum paint job.
Next up was a Warne Mountain Tech 0MOA Rail & Warne Mountain Tech 30MM rings.
For the bolt I purchased a Mountain Tactical threaded bolt handle & an APA 5/16X24 knurled bolt knob.
For the barrel, I went with a prefit 24" #2 contour beadblasted finish from Preferred Barrels.
The rifle with the rail/rings is right at 7.5lbs prior to mounting a scope.
What scope is currently on a TBD status
Well, I finally pulled the trigger.
Thus far here is where I'm at.
Started life as a T3 stainless in 30-06.
Scavenged a T3x stock, added the OE vertical grip, Limbsaver, & a Rustoleum paint job.
Next up was a Warne Mountain Tech 0MOA Rail & Warne Mountain Tech 30MM rings.
For the bolt I purchased a Mountain Tactical threaded bolt handle & an APA 5/16X24 knurled bolt knob.
For the barrel, I went with a prefit 24" #2 contour beadblasted finish from Preferred Barrels.
The rifle with the rail/rings is right at 7.5lbs prior to mounting a scope.
What scope is currently on a TBD status