Sam's dad
Lil-Rokslider
- Joined
- Dec 13, 2016
- Messages
- 209
Hey guys, I could use some advice. I have several arrows that aren't spinning true on the spinner. These are Easton Axis with a field points and inserts that I picked up from my local shop.
I have a G5 ASD to square the ends, but the inserts are epoxied in place. What do you recommended - Square the ends of the inserts? Or remove the inserts, then square the arrow, then re-epoxy the inserts, and square the insert? Something else? If it's best to remove the insert, can I use heat to break the epoxy or will the heat mess with the carbon?
I'm pretty handy but want to make sure I'm doing it right.
Thanks.
I have a G5 ASD to square the ends, but the inserts are epoxied in place. What do you recommended - Square the ends of the inserts? Or remove the inserts, then square the arrow, then re-epoxy the inserts, and square the insert? Something else? If it's best to remove the insert, can I use heat to break the epoxy or will the heat mess with the carbon?
I'm pretty handy but want to make sure I'm doing it right.
Thanks.
Last edited: