HIT insert help

[Remps17]

New to the HIT insert and was wondering are you guys using the Easton epoxy? I wanted the ability to play around with insert weight. Any suggestions with out giving up the strength?

Cheers

 

[Jtelarkin08]

I have had issues anytime I have used anything other than the epoxy. If your just wanting to tinker some you can use hot melt. Once you decide what you want to use heat up your field tip and pull them clean the shaft and then re install them with epoxy.


Sent from my iPhone using Tapatalk

 

[Remps17]

I have had issues anytime I have used anything other than the epoxy. If your just wanting to tinker some you can use hot melt. Once you decide what you want to use heat up your field tip and pull them clean the shaft and then re install them with epoxy.


Sent from my iPhone using Tapatalk

Never thought about that. Thanks

 

[Don Qui Puncher]

much easier playing with field point weight, ive done the hot melt and heat reversible glue and its a pain, the amount of work you have to do after to clean the shaft so another insert will fit is a pain