Feb 9, 2020 #1 Gonz406 Lil-Rokslider Joined May 25, 2019 Messages 180 Location MT Took my bow out this morning and noticed the bearings on the roller cable guard were a little noisey. Kinda like they were spinning a lot longer after my arrows was launched. Any experience with this or how to get rid of it?
Took my bow out this morning and noticed the bearings on the roller cable guard were a little noisey. Kinda like they were spinning a lot longer after my arrows was launched. Any experience with this or how to get rid of it?
Feb 9, 2020 Thread Starter #3 OP Gonz406 Lil-Rokslider Joined May 25, 2019 Messages 180 Location MT Hoyt nitrux
Feb 9, 2020 #4 OR Archer WKR Joined Feb 29, 2012 Messages 3,035 Location Mesa,AZ Are the bolts holding the roller snug? If they’re loose don’t over tighten them. Snug them up then take a 1/4 turn off.
Are the bolts holding the roller snug? If they’re loose don’t over tighten them. Snug them up then take a 1/4 turn off.
Feb 9, 2020 Thread Starter #5 OP Gonz406 Lil-Rokslider Joined May 25, 2019 Messages 180 Location MT OR Archer said: Are the bolts holding the roller snug? If they’re loose don’t over tighten them. Snug them up then take a 1/4 turn off. Click to expand... They're tight
OR Archer said: Are the bolts holding the roller snug? If they’re loose don’t over tighten them. Snug them up then take a 1/4 turn off. Click to expand... They're tight
Feb 9, 2020 Thread Starter #6 OP Gonz406 Lil-Rokslider Joined May 25, 2019 Messages 180 Location MT Loosened them up, problem solved!!! Thanks!!