My thoughts exactly.
This past week I was at our rifle range and a guy I know was breaking in a new 7PRC with factory ammo. He was shooting factory ammo with the exact same bullet I was using in my 280AI with reloads. 35 fps difference in the 2 rifles per a Garmin Chrony.
I quit Barnes a long time ago so have no personal experience with these tipped bullets but I’d bet you a cold one that beyond 300 yds or so the accuracy would not be good. It is just simple aerodynamics.
I’ve hunted antelope for 50+ years in 3 different States. As a guess I’d say 60% were taken prone, 35% taken sitting and 5% (Maybe less) were taken off hand or kneeling.
Depending on the terrain and height of sagebrush, prairie grass etc. shooting prone at times is not an option - you just...
I’m going to bet you have one of the mounting screw holes tapped on the model 70 that is not tapped dead center on your action. Been there - done that. Run a long straight edge down the center of your barrel and action paying no attention to the 4 tapped screw holes. When straight edge is in...
If you can’t resize your once fired brass I wouldn’t fight it very long - been there, done that. Rather than rebarrel I’d take it to a competent gunsmith and have him clean out your chamber by running a SAAMI reamer into your chamber to clean it up and also give you the proper OAL to your...
Been using electric fence for many years. i highline at night whenever we are in moose country or very far back in the backcountry, especially in early to late fall during the moose rut. Moose can make a pretty good tangle out of any wire and they go wherever they want.
https://www.crazycrowgunworks.com/product-page/precision-turret-stickers
Here’s one custom turret label outfit- there are a couple of different ones on the internet.
I still have and use one of the original Huskema scopes. Has never let me down. I’ve had it in every imaginable type weather, been in rifle scabbard on horses for more miles than you could imagine.
Rather than getting a factory turret cut which may be needed to be changed with different loads...