CTR stock and aftermarket barrel fitment?

[strow]

I haven't seen this specific question asked, or can't find it in the search.

I have a factory Tikka CTR stock (injection molded) and am wondering if an aftermarket Remington Varmint or M24 profile Bartlein, Krieger, Brux, and MullerWorks will fit the factory CTR factory stock until a Manners EH1 arrives?

Or what is the heaviest profile barrel that will fit in the factory CTR stock without getting the Dremel out.

 

[Macintosh]

An mtr certainly wont. The ctr barrel profile is very similar to a “light Palma” contour. Its got a little more clearance than the lite stocks do, so maybe a little wiggle room, but you’ll need to modify the stock to fit much heavier of a barrel.

 

[strow]

Thank you for the reply! I'll keep looking for light palma contours or smaller then.